3D Printing Improves Testing for Gas Turbine Components

Gas turbines are complex components to manufacture, but additive manufacturing has been successfully utilized to accelerate design cycle times, reduce development test times, provide better test data and reduce the overall time to the release of the final component. It also allows for testing to be performed earlier, as early as the concept or preliminary design phases. This means that there is less likelihood that the entire component will have to be redesigned, as problem areas can be detected and eliminated early.

In a recent case study, a Siemens Energy SGT-A05 industrial gas turbine engine line was manufactured, and additive manufacturing was used for aerodynamic development testing within the preliminary design phase for boundary condition definition of new compressor static flow path components.

“The model test section for this work was designed to characterize the influence of the internal flow passage and the exit plane flow coming from the zero-stage compressor both with and without handling bleeds active,” the manufacturing team explains. “The flow passage is defined with a symmetric center-body, which represents a combination of rotor components and static end walls, and an asymmetric outer-body for bleed.  All structural static internal components, e.g. struts used for sump services and bearing support, were included in the model. The test model was a geometrically similar 1/5th scale model of the stage 0 module of the engine. Focus for the test models was on the internal static flow path features only and, where possible, split line effects associated with the actual engine assembly were replicated.”

The parts were 3D printed using a Formlabs Form 2 3D printer, and once they were cured, they were fastened together using epoxy to create an airtight and spatially correct flow path. To improve the overall strength, the assembly was then epoxied into an 8-inch diameter, standard-wall, black-iron pipe section and back-filled with a polyester resin. The whole process, from CAD drawings to creating the assembly, took about two weeks and 30 man hours of work.

Two different model standards were tested over 20 different inlet conditions, completed in less than five months. Several repeated tests were conducted to assess data quality, reproducibility, and the consistency of transient effects. All of the testing indicated high accuracy and low variability.

“Results from testing have demonstrated high value to the current re-design program,” the team states. “Not only was the data made available during the entire preliminary design phase, working between test and engineering allowed easy utilization of the data being generated.  In general, this new boundary condition data has demonstrated direct benefits to the current design, which incorporates a non-axis symmetric inlet profile feeding the high pressure compressor and also has incorporated factors which mimic the noted dynamic pressure effects associated with bleed into the design.”

Overall, it was determined that using additive manufacturing greatly improved the testing process, with the following aspects noted:

• Rig development time was improved by roughly an order of magnitude
• Rig and test component prototype costs were reduced by three times
• The technical validity of the results was only slightly lower than fully instrumented engine test results but improved relative to typical component testing
• The test results showed exceptional agreement to full scale 3D CFD results driven by rig test defined boundary conditions
• The total cost comparison of current vs. conventional testing was four to 10 times lower and resulted in more than an order of magnitude more data

You can read the full study here.

Discuss this and other 3D printing topics at 3DPrintBoard.com or share your thoughts below. 

If you're looking to request photorealistic CGI in the USA, our service offers an easy and efficient way to get stunning, lifelike renderings for your architectural and real estate projects. Through our platform, you can quickly request high-quality CGI images that accurately capture the essence of your designs. Whether it's for a residential or commercial property, our experts specialize in creating realistic 3D renderings that highlight every detail, bringing your vision to life with exceptional clarity and precision.

Through our website, requesting photorealistic CGI becomes a seamless experience. With our help, you can get highly detailed 3D visualizations that look just like photographs, providing a realistic representation of your project before it's even built. Our team ensures that every element, from textures to lighting, is meticulously rendered, giving you an impressive, lifelike result that will leave a lasting impact on your clients and stakeholders.